My Yacht Surveyor Experience

In the last ten years I have performed close to 60 of these types of yacht surveys all over Florida and up the east coast in Georgia, South Carolina, North Carolina and Virginia. All are well made capable yachts with features that allow them to cruise for extended periods of time. Along with this capability comes complexity of systems and features that need to be examined during the survey to evaluate their condition and function. These surveys are not one day affairs.

The amount of experience I have is helpful. The reports I have on file are good references when I am going to be surveying a similar model or in some cases the same boat over again. I have furnished anonymized sample surveys for clients so they may do the same and have an idea of what they will receive when the job is completed.

The Process

Some flexibility can be accommodated during my yacht survey process but generally the first day is accomplished dockside to allow time to go through the boat without interruption of the shore power and the noise of machinery drowning out the equipment being operated. Appliances such as clothes washers, dishwashers, refrigerators, freezers and air-conditioners are better evaluated without stopping and starting them. AC generators will be operated, closely monitored and loaded to capacity if possible.

During the dockside inspection the locations of equipment that will be used underway such as engine controls, steering components, thrusters, stabilizers and rotating equipment can be noted. If removals are necessary to access them during the trial-run this will be determined and done before getting underway. Deck equipment such as the windlass and tender loading gear will be operated. The tender will be evaluated. Lead acid batteries and chargers will be located and tested.

Navigation electronics are also evaluated during the dockside inspection. Far better to go through their various features, evaluate their function, and ask questions without interfering with the piloting of the vessel. Underway piloting is job number one! After the dockside inspection, the autopilot and stabilizers are generally the only pieces of equipment that will not have been fully evaluated.

The second day the vessel will be hauled to check its underbody and make sure it is adequately cleaned for the trial-run or sea-trial depending on the proximity of the survey to open water and conditions at the time of the survey. It will be run through its paces using the main engine(s) and wing engine if so equipped. Trial-runs also provide an opportunity to evaluate inverter systems and the engine alternators that maintain the batteries while they are in use.

I usually work alone but have associates and I can call on to help with surveying larger yachts.

Upon returning to the dock from the haul-out/trial-run the boat will be tied up and shore power restored. Fluid samples will be taken from the machinery then a meeting usually takes place to review what has occurred during the survey. After all that it is time to leave.

Reporting

My yacht survey reports, and fluid analysis when that is part of my survey will usually be ready within two to three days after I return to my office. Sometimes travel adds a day to the process. I send several emails. One email with the survey findings (“The list”). Then the full report pdf and dropbox link to the survey photos. After that I make myself available to review and answer questions as needed.

Sample Surveys

Click for sample surveys:

Kadey-Krogen 39 2004
Nordhavn 55 2006
Selene 53 Ocean Trawler 2004